BBQ TABLE

• Material list
• 95x45,75x45 Treatment h3.2, nails 90x3.8 Galv ,Engineering Bolts 110x12mm washers

1. Measure and cut and plane 95x45
2. measure and cut table top 1600 mm and seat bearings
3. nail 95x45 to table top bearers with 150mm over hang
4. cut table legs which are cut at a 30 degree angle and are 900mm long
5. nail legs to seat bearers only when legs are squared off the top
6. nail top of the legs to table top bearers
7. square up legs with roofing square
8. trace and cutt and nail braces from seat bearers to centre of the table top
9. nail seat slats off
10. finish off with drill and screw bolts where legs and bearers meet
11.